Is there an existing issue for this?

• I have searched the existing issues

Current Behavior

My setup:

While holding "Guide" on Set 1,
it will switch to Set 2.

Then while holding "Select" on Set 2,
it will switch to Set 3.

Then on Set 3,
pressing the "B" button will execute a .bat file.

Problem:

If I do: "Select + Guide",
instead of: "Guide + Select",
I will end up stuck on Set 2.

Same thing happens if after pressing: "Guide + Select",
I release "Guide" before releasing "Select".

Expected Behavior

When pressing the buttons in the wrong order: ex: "Select + Guide" instead of "Guide + Select", nothing should happen until I perform the correct sequence.

Or

If I release all the buttons, it should always go back to Set 1.

Steps To Reproduce

1. While on Set 1, assign a button to change to Set 2 while held (let's say: A).
2. While on Set 2, assign a different button to change to Set 3 while held (let's say: B).
3. Instead of performing the correct "A + B", proceed with "B + A".
   Or
   After performing the correct "A + B", instead of releasing "B then A", proceed with releasing "A then B".
4. Congratulations, you are now most likely stuck on Set 2.

Environment

- OS: Windows 11
- AntiMicroX version: 3.2.2

Anything else?

No response